When it comes to mixtures in general and mortar in particular, it is essential to keep in mind the proportions of the materials that we are going to use.
Therefore, the first thing is to be very clear about the proportion of each element to mix.
Proportions in the mortar mix
As a general rule of thumb, use a ratio of 1 part cement (Portland or gray) to 1 part water to 4 parts cement sand.
Depending on the type of cement (for example, for masonry), that is, a finer work, the proportion should be 1 part cement to 3 parts sand.
Being practical on site, and to quickly obtain the size of each of the parts, we can use something that we normally have close at hand, for example, a shovel.
Obviously, depending on the desired amount, if more or less is required and since the mixture is proportional, it can be used by doubling, tripling or dividing the amount in question.
Traditional way of mixing mortar
The traditional ones are made by hand inside the wheelbarrows or directly on the ground.
First, mix the dry ingredients together to form a small mound, create a kind of crater in the center and add the corresponding amount of water into the hole you have made.
mix with hoe or with your own shovel, then add the rest of the water that is necessary until you get the right texture.
How to mix the perfect mortar
At this point it must be said that, when mixing the mortar, you can use a specific tool for this task: an electric mixer.
El electric mixer it is better both because of the result that you are going to get in the end and because you are going to save considerable effort and time.
This recommendation is greater the more amount of mortar we need to mix to use in our work or project.
En toolsbazarot.com you can choose a mixer for both cement mortar and adhesive mortar.
They are characterized by the advanced design of the rod and its adaptability to various ranges of elements to be mixed, such as adhesives, paints...
Finally, here are two basic tips for properly mixing your mortar.
2 tips for mixing mortar
If you use an electric mixer or mixer, try to make the mixture in a bucket or carrycot.
To check if the mortar has the right viscosity, simply apply a small amount to the plain and turn it over.
If it does not fall off, it is ready and willing to start being applied.
